CyberALADDiN
(M1644/M1644T) Chipset CyberALADDiN
CyberALADDiN-T (支持Tualatin
CPU)
Core Logic Chipset for Intel Mobile Pentium III & Tualatin Processors
CyberALADDiN-T combines two high performance chips, Acer Labs'
ALADDiN-Pro 5 north bridge and Trident's CyberBlade XP graphic accelerator.
It is the industry's first mobile integration chipset with 128-bits dual
pixel graphic engine and DDR memory support.
Benefits of DDR Technology
CyberALADDiN-T uses SMA (Shared Memory Architecture) to eliminate the
need of local frame buffer. In the past, SMA was considered by some as low
in performance due to inadequate memory bandwidth. With graphic core
improving the speed drastically and CPU’s need to access main memory
simultaneously, SDR’s bandwidth is not enough. The arrival of DDR memory
technology will change this impression. By transferring twice amount of data
of the original SDR memory, memory bandwidth is no longer the bottleneck for
graphic integration chips. Consequently, the support for high resolution
panel without losing overall performance is feasible. Furthermore, DDR
memory operates at 2.5V and using the scheme of delaying write data from
command will lower the power consumption. Therefore, DDR memory is a perfect
fit for mobile space.
Core Logic Features
The north bridge is based on ALi's ALADDiN-Pro 5 chipset (M1651) which
supports Celeron , PentiumR II, PentiumR III and Tualatin family of CPUs
with front side bus (FSB) of up to 133MHz. At the same time, this chip
interfaces with traditional PC-133 SDRAM and advanced DDR-266 memory with
peak bandwidth reaching up to 2.1 GB/sec. Key core logic features are listed
as following:
- Supports all IntelR Slot-1/Socket 370 PentiumR II, PentiumR III,
Celeron and Tualatin processors.
- 64-bit data bus and 32-bit addressing.
- Supports back to back write transfer.
- Optimized processor command scheduling and reordering.
- Supports up to 512 Mbit SDR/DDR SDRAM.
- Maximum memory size: 3 GB.
- x-1-1-1-1-1-1-1 back-to-back page hit.
- CAS before RAS and self refresh for SDRAM.
- Fully compliant with PCI Rev. 2.2.
- Dynamic memory pre-fetch algorithm and programmable post write flush
algorithm.
- Supports concurrent PCI bus burst transfer at zero wait-states.
- 133 MB/sec data streaming for PCI bus to memory with minimum latency.
Superior 3D/DVD Engine
CyberALADDiN-T possesses 128-bits 3D/DVD engine. Besides all standard
features that most graphic accelerators support, CyberALADDiN features cubic
map lighting, multi-textured, full-screen anti-alias, and texture edge
sharpening.
In addition, by incorporating THAMATM (Trident Hardware Assisted MPEG-2
Acceleration), hardware motion compensation and Inverse Discrete Cosine
Transform (IDCT) are supported. Ultimately, CyberALADDiN-T delivers an
advanced digital media capability.
Graphic Logic Features
CyberALADDiN’s graphic engine is based on Trident’s Cyberblade XP. It
possesses dual pixel pipes and a hardware transform and lighting (T&L) unit
to provide sufficient rendering power to meet high-end graphics demands. In
addition, CyberALADDiN integrates high speed LVDS with external spread
spectrum support to reduce EMI. On the panel side, this chip is capable to
support SXGA and SXGA+ high quality panel. Key graphic features are listed
below:
- 128-bit internal data path running at 133MHz clock.
- 256 Raster Operations (ROPs), single-cycled.
- Full-featured DirectX 7.0 implementation.
- Set up engine with 32-bit IEEE floating point precision.
- Lighting engine with per pixel, diffused and specular reflection
lighting.
- Advanced Rendering engine.
- Texturing engine with single-pass multiple-textures processing.
- DVD hardware assist with Motion Compensation.
- Integrated LVDS transmitter.
Power Management
Coupled with ALi’s feature-rich south bridge (M1535+), CyberALADDiN-T
achieves a low power solution for mobile platform. Dark Green Power
Management functions such as Power on Suspend, Suspend to RAM, Suspend to
Disk, PCI bus, CLKRUN and Dynamic Clock stop are all supported. On the
graphic side, the 3D/2D engines are dynamically clocked down when idle
without software intervention. AGP power management is implemented through
BUSY# and STOP#. Mini-driver function calls are used to support ACPI.
The scheme of graphic controller and north bridge integration reduces the
cost for PC manufacturers. The 128-bit dual pixel engine with DirectX 7.0
support and THAMA architecture bring high end graphic performance with
unparalleled digital media capability. Finally, with DDR memory support,
power consumption is significantly reduced. Taking into account of cost,
performance, and power, CyberALADDiN is the exact solution for the mobile
space.
Key Features |
Benefits |
Tualatin CPU compliant host
bus |
Flexible CPU interface to support
both Intel Pentium IIITM and Tualatin CPU |
Pentium Class Processor
Support |
Flexible CPU interface to support
both Intel Pentium II/III and Intel Celeron |
Flexible Memory controller
to support SDR and DDR. 200/266MHz memory bus |
Supporting DDR 200 and DDR 266Mhz
which double the traditional memory bandwidth to maximizes the 3D
graphics and demanding internet application performance through support
of high speed DDR200/266 memory especially on UMA architecture |
Proven Core logic |
Integrating based on the M1651
Aladdin Pro 5M core |
SMA |
Shared Memory Architecture to
reduce memory cost for graphics frame buffer. Frame buffer sizes can
configured to :4MB, 8MB, 16MB and 32MB |
Advance Mobile Power
Management |
Supporting all ACPI states and
BUSY#, STOP#, PCI CLKRUN#, etc.. to increase battery life longer. Also
supports ACPI and legacy APM power management for energy saving and
prolong battery life. |
LVDS and Spread spectrum
integrated |
LVDS built-in to reduce board sizes
and better control on EMI noise emission. |
Flexible 66/100/133MHz
front side bus frequency |
Optimize the performance of whole
range of Intel P6 CPU including Intel Pentium III, Intel Celeron
processors running at various FSB speed |
128 bit Dual Pipe line 3D
and 2D Graphics and 128 Bit Northbridge |
Maximizing performance for 3D
graphics performance by increasing the pipeline to benefit on 3D
applications, 3D game and video application. Also increase internal
memory interface to improve system performance. |
Advance 3D Graphics quality
like: Cubic Map Lighting, Anisotrophic Filtering (Trilinear),
Multi-textured & Bump Mapping, texture Edge Sharpening, Full Screen
Anti-Aliasing |
- Cubic Mapping Lighting –
Light maps easy to generate and less computational
- Anisotrophic Filtering – to
have more vivid for realtime games and 3D Web browsing.
- Multi-texturing – obtaining
the best quality/effect with multi-texturing with vivid graphics
quality compared with single texture.
- Texture Edge Sharpening-
Improved the texture edge sharpening for Internet 3D gaming with low
resolution and expand textures bandwidth with high quality graphics
|
Video Support |
Support external TV encoder.
Support 1280x720 HDTV resolution and advanced de-interlacing. |
DVD/VCD Support |
IDCT and Motion Compensation for
MPEG II decompression. This improves the video quality on DVD movie
playback as well as VCD |
Advanced 3D Graphics Engine |
Supporting Transformation and
lighting, 3D Rendering Engine, 3D binning and 3D Setup Engine processing
rate for 3D animations and real time video quality |
ATA-100 interface |
Enhance the system performance
throughput with fast response of HDD connection |
AC-97 Support |
Delivering high quality audio for
cost effective solution |
Software modem |
Provide low cost internet connect
capability through AMR fax/modem add-on module |
6 USB ports |
Provides external “Plug n Play “
capability for USB devices to enable legacy free system design
|
SPDIF |
Sony Philip digital interface to
support analog input and output signals for high fidelity sound quality. |
Low power consumption |
Supports DDR266 SDRAM low voltage
(2.5V vs. 3.3V) memory interface to benefit portable design such as
notebook , set-top-box. |
Integrated Super I/O |
Reduce board size and cost to
integrate into single chip south bridge. |
|