| Socket370
for Intel PIII Processor |
- Intel Celeron FC-PGA with 66 / 100 MHz FSB
- Intel Pentium III FC-PGA with 100/133 MHz FSB
- Intel Pentium III FC-PGA2 with 133 MHz FSB
|
| (North) Intel 82815EG
(B-step) Memory Controller Hub l Host interface |
- Host interface
- AGP interface
- SDRAM interface
|
| (South) Intel I/O
Controller Hub 2 (ICH2) |
- AC97 Controller
- UDMA 33/66/100 IDE interface
- USB interface
- Integrated LAN MAC
- Power management meet ACPI requirement
- RTC
|
- Mini Flex ATX Form Factor
|
- 2 x 168-Pin DIMM Sockets Support 8MB to 512MB PC100,133 SDRAM
|
| LPC I/O
(Winbone 83627 HF) |
- Comply with Intel Low Pin Count Interface Specification Rev. 1.0
- ACPI V. 1.0 compliant
- Built in H/W monitor
- Two 16C550 UARTs
- Supports two standard Serial Ports
- Supports IrDA 1.0/ASKIR protocols
- IEEE 1284 Parallel Port
- Standard mode -- Bi-directional SPP compliant
- Enhanced mode -- EPP V. 1.7 and V. 1.9 compliant
- High speed mode -- ECP, IEEE 1284 compliant
- Floppy Disk Controller
- Supports two 360K/ 720K/ 1.2M/ 1.44M/ 2.88M floppy disk drives
- Enhanced digital data separator
- 3-Mode drives supported
- Keyboard Controller
- Game Port
- Dedicated MIDI Interface
- Support power-failure resume and power button de-bounce
|
| Hardware
Monitor (Winbone 83627HF) |
- 1 thermal inputs from remote thermal resistor to monitor system
temperature
- 2 thermal inputs from thermal diode to monitor CPU temperature
- 9 voltage monitor inputs
- 1 chassis intrusion input (For OEM project only)
- Monitors 1 fan tachometer inputs
- Smart Guardian Controller to provide programmable fan speed
automatic control
|
- 1 x PCI Expansion Slot
- PCI 2.2, 32-bit BUS Master Slot
|
- 2Mb BIOS with Full ACPI, APM, DMI, Green, PnP
- Support boot from FDD / IDE / ATAPI / SCSI / USB device
- CPU Multiplier Ratio Selections
- Support FSB adjustment from 66 – 150MHz
- Support IRQ manual assign table
|
| PC’
99 Color-Coded I/O Ports |
- 4 x USB Ports (Support Hot-Plug Function)
- 2 x Com Ports, 1x Parallel Port (EPP, ECP)
- 1x PS/2 Keyboard Port, 1x PS/2 Mouse Port
- 1x game / MIDI Port
- 1x Line in, 1x Line out, 1x Mic
|
| UltraDMA/100
IDE controller On board Promise 265R |
- 2 x UltraDMA/100 Bus Master IDE from ICH2
- 80-pin Cable Backward Compatible Legacy ATAPI Devices
- ATAPI IDE CD-ROM, CD-R, CD-RW, and LS-120 Supports
|
- 16 bit Stereo Full-Duplex Codec
- PHAT Stereo 3D Stereo Enhancement
- High Quality CD input with ground sense
|
- FSB: 66/70/75/80/83/100/105/110/115/133/137/140/145/150MHz (BIOS
Setting)
- Multiplier: Low Ratio 5.5 to 12 High Ratio 7.5 to 16
|
| ATX 20
pin Power Connector |
- ATX 20-pin Power Connectors for 3.3V, 5V, 5VSB and 12V
|
- Support multiple system suspend types- suspend to DRAM, suspend to
disk, and all with hardware automatic wake-up
|
- 1x Floppy Port(Up to 2.88 MB, 3 Mode)
- 1 x FAN Power Connector
- 1 x Wake On Ring
- IrDA Tx/Rx Header
- 2 x Front Panel USB Connector Header
2 x Rear USB ports on board
- AUX in
- TAD in
- CD Audio in
|
- Clear CMOS
- BIOS Boot block protection
|
- 1 CD-ROM disk contains software driver & Utility
- 1 user manual
- 1 ATA66/100 IDE cable
- 1 FDD cable
- 1 Heat Sink attached on North Bridge
|
|
