| 
    
    PRoute112 
    Dual 
    V.90 WAN Port Router  | 
    
    
      | 
   
 
FEATURES  
  - One 
  page quick configuration setting to Internet 
 
  - 
  User-friendly WEB management for system con figuration 
 
  - 
  Integrated V.90 Modem, Hub and Router function 
 
  - MNP10 
  dynamic data rate fallback/forward mobile operation 
 
  - Dial On 
  Demand (DOD) ease connection to Internet automatically 
 
  - Idle 
  timer setup to disconnect line automatically for saving communication cost
  
 
  - Dial-in 
  function for remote access application 
 
  - DHCP 
  (Dynamic Host Configuration Protocol) function assigns relative Ethernet 
  setting reducing load of network administration 
 
  - NAT 
  (Network Address Translation) allows dynamic network address translation of 
  local domain 
 
  - Call 
  back connection for security access control 
 
 
DESCRIPTIONS
 
  
PRoute112 
is a suitable SOHO (Small Office Home Office) 
router used by branch office or home users. With the dual V.90  
modem ports you can connect to the headquarter and ISP to  
access host database and Internet simultaneously. Or you can  
combine the two lines to connect the same location under  
ML-PPP to expand the throughput.  
The Dial 
ON Demand (DOD) function can save the connection  
cost for daily operation. PRoute112 will automatically dial-up to 
the remoe destination if there is a packet to the remote site.  
PRoute112 also performs dynamic banwidth management with  
a pre-set threshold. It monitors the traffic throughput and determines  
to add or drop one link by the threshold.  
The 
dial-in function let users to access office database from outside to  
refer necessary data after work.  
Call back security ensures that only valid users can acess the network. 
 
WEB based 
configure software makes PRoute112 configuration setting  
easily by clicking mouse. 
SPECIFICATIONS  
Modem Interface 
  - 
  Downstream up to 56kbps 
 
  
  - 
  Upstream up to 33.6kbps 
 
  
  - 2 x 
  RJ11 modular jack 
 
  
  - Half or 
  full-duplex operation 
 
  
  - Auto 
  dial/answer, MNP10 auto fallback 
 
  
  - Comply 
  with Bell 103;212A,ITU-T 
 
  
  - 
  V.21;V.22;V.23;V.22bis;V.32;V.32bis;V.34;K56flex;V.90 
 
  
  - ITU-T 
  V.42, MNP4 error correction 
 
  
  - ITU-T 
  V.42bis, MNP5 data compression 
 
  
  - V.54 
  loop test 
 
  
 
Ethernet 
  - IEEE 
  802.3 
 
  
  - 4 x 
  10BaseT Hub port 
 
  
  - RJ45 
  modular jack 
 
 
Router 
Protocol 
  - PPP 
 
  
  - ML-PPP
  
 
  
  - DOD 
 
  
  - TCP/IP
  
 
  
  - NAT 
 
  
  - DHCP
  
 
  
  - PAP 
 
  
  - CHAP
  
 
  
  - Data 
  compression 
 
  
 
Management 
  - Telenet
  
 
  
  - Call 
  back security 
 
  
  - Dial in 
  function 
 
  
  - On-line 
  traffic monitoring 
 
  
  - WEB 
  management 
 
 
Analog 
Port 
  - 2 x 
  RJ11 modular jack 
 
  
  - -48VDC 
  power feeding 
 
  
  - DTMF 
  dialing 
 
  
 
Data 
Port 
  - DB-9 
  female connector 
 
  Enhanced AT command  
  Router command  
  Auto-baud detection  
  Up to 230.4k DTE speed  
 
LED 
Display 
  - Power, 
  Gree : power is on 
 
  
  - Off : 
  power is off 
 
  
  - LAN, 
  Green : Ethernet data transmission 
 
  
  - ER, 
  Green : RS232 port connected 
 
  
  - Off : 
  not connected 
 
  
  - TX/RX, 
  Green : transmitting/ receiving data 
 
  
  - Line, 
  Green : 1-line is busy 
 
  
  - Orange 
  : 2-ine is busy 
 
 
Maintenance 
  - Flash 
  EPROM for software upgrade 
 
  
  - Minimum 
  operating mode 
 
  
  - Factory 
  default setting 
 
  
  - Power 
  on self diagnostic 
 
 
Power 
  - 
  100~250VAC, 50/60Hz 
 
  
  - 
  Overload protection 
 
 
Operation 
Humidity 
Dimension 
 |